|
|
Motoflow
is the product that launched Ecoflow in 1991 and has been saving hundreds
of thousands of motorists around the world millions of pounds ever since,
not to mention the considerable reduction of pollutants being released
into the environment.
Hydrocarbon molecules are very complex, and a small change in the molecular
structure can mean big changes in the end product. As an example the only
difference between petrol and diesel is a few carbon atoms!
Fuel that has been subjected to the Motoflow magnetic field has benefited
from electron movement, producing molecules that combine more efficiently
with oxygen.
This action allows for a quicker and more complete combustion, resulting
in more energy being available earlier in the combustion stroke of the
engine. An increase in power and torque and a reduction in pollutants
are generally noticeable. The combustion chambers tend to remain ‘cleaner’,
that is less carbon is deposited in the areas of combustion allowing gases
to flow freely.
Modern engines are fuel injected and continually monitored electronically
to optimise their performance. They are therefore considerably more efficient
than engines built in 1991. However, that does not mean that they cannot
benefit from Motoflow in the long term. Reduced pollutants result in an
extended life of catalytic converters (expensive to replace) and the cleaner
burn helps to extend the efficient life of the engine.
How
soon will I see some improvements?
It depends on the condition of your engine and your driving
style. As a guide allow up to 1,000 miles for a petrol engine and a little
more for a diesel. Remember, a better combustion will give more power,
but it is the driver’s foot that dictates whether the additional
power is used to accelerate quicker or improve fuel consumption!
Will
fitting a Motoflow affect my warranty?
No, provided it is fitted in accordance with the instructions.
There are no pipes to cut and original equipment is not tampered with.
What if I change my car / van?
No problem. Simply remove the Motoflow and fit it to your
new vehicle!
Thermoflow
is
designed for use on oil and gas heating appliances to reduce fuel costs.
Appliances that are fitted with Thermoflow also benefit from lower soot
levels that reduce maintenance costs.
As with the Motoflow, the Thermoflow conditions the fuel to burn more
quickly and more efficiently, this ensures the maximum amount of fuel
is burned within the length of the flame. Using a Thermoflow provides
more heat from a given amount of fuel allowing the energy requirements
of the appliance (boiler, heater, oven etc.) to be reduced.
How will I know if I am saving fuel?
By comparing to your previous fuel bills. It is quite common
that customers who pay their bills monthly by standing order have their
monthly payment reduced by the fuel supplier after a few months of fitting
Thermoflow.
What is the average saving?
It is not possible to be definitive about the amount of
fuel that will be saved, this will depend on the type and condition of
the boiler. In general terms customers report savings in the range of
5 - 20%.
Do I have to make any adjustments to
the boiler?
Fitting a Thermoflow will accelerate the heating process
and often this allows the water to get a few degrees hotter before the
thermostat cuts in.
If this happens then turn the boiler thermostat down on the control to
save more fuel.
|